Arctic Thunder Kustoms


For a consultation contact Eric : eric@arcticthunderkustoms.com

DESCRIPTION FOR THE POLARIS RZR SNORKEL KIT:

Fits 08-2014 RZR std and S models. These are the snorkel kits needed to pull off those You Tube videos, and completely blow your friends away !!! This is a complete snorkel kit. WARRANTEED AGAINST BREAKAGE!!!  Much time was spent developing this system with regards to fit and function. These kits pull fresh air from the top of the cage. This provides incredibly deep water excursions, as well as allows the engine to draw in the coolest cleanest air. Another big plus is noise is greatly reduced by moving the intake and clutch discharge above your head. Notice the clear view through the rear of the machine - there is virtually NO vision obstruction - this is a big plus when negotiating tight trail maneuvers. They are 2 piece so snorkel and bed removal is easy for cleaning and maintenance. We have also separated the engine intake from the clutch intake and exhaust. When these three systems are located close together, the hot clutch exhaust could contaminate the intake charge. This kit can be used with or with out the lock and ride rear rack system and MOST accessories. We also give you the tubing to extend all the necessary vent lines, as well as all the hardware, clamps and instructions for a complete water tight system.  Nothing has been left out!!!!

** Kits  include rubber caps for storing and trailing your RZR - keeps animals and moisture out!!!!!**

MATERIAL:

We only use ABS pipe. No matter how much you scratch this stuff it will stay black. My system is painted for UV PROTECTION of exposed parts and a clean look. As far as strength, the upper portions are clamped to the stock cage, for a rugged and rattle free installation. The systems themselves are very strong and near impossible to break when properly mounted. This kit will last you many years under normal use. In fact if you break any portion, I will send you a replacement. (up to 1 year from purchase date). The fittings we use are smooth radius/ minimal restriction for maximum cooling efficiency and HP! Other kits using tight radius fittings will rob your machine of power - Like pressure pvc - that stuff is designed for pumping water at high pressure, not feed and engine trying to suck air!!  NOT GOOD!

CONSTRUCTION:

I am a Master plumber by trade, and have been building custom everything for 20 years. These snorkel kits are built with the best workmanship you will find, all pieces are cut on a chop saw - square, then chamfered and beveled for a perfect fit in each fitting. After each section is assembled, it is pressure tested to insure there are no leaks - could you imagine?!? And that's right I said ASSEMBLED!! Your kit will arrive ready to bolt on - no need to buy glue, and align fittings. All you have to do is drill a few holes, pull the bed off and make 1 cut to an existing duct. You can do this in about 1-2 hours start to finish and your machine will be ready to go as deep as you dare - you may want to keep a life jacket on board!! My kits are priced higher than the rest because you get 3 times the product - literally. They are PRE-ASSEMBLED. They are PRESSURE TESTED for reliability. They are custom built to blend in with the stock roll bars. Simply put, they are THE best!! Oh and free shipping - no hidden cost!!

 

 

 

 

 

 

 

Snorkle

 

 

DISCLAIMER:  Do not operate the machine through water deeper than the manufacture recommends. Any operation beyond the manufactures recommendation is at YOUR OWN RISK. I accept no liability as to the performance of this product, or your safety, it is intended only to convey clean cool air to the machines vitals drawn from the highest possible point of the machine.

Pittsburg Ridge Runners   |  HCS  |  SteepNDeepCrew  |  AMSnow  |  Livingston's  |  Home  |  About Us  |  Contact Us
All Content © 2009 Arctic Thunder Kustoms