Arctic Thunder Kustoms

For a consultation contact Eric :
Pittsburg Ridge Runners   |  HCS  |    |  AMSnow  |  Livingston's  |  Home  |  About Us  |  Contact Us
All Content © 2009 Arctic Thunder Kustoms
Polaris 2013 RZR XP Snorkel Kit:     $325.00
Free Shipping to the Lower 48 States



Our RXR 900 kit is built to perform! We use huge 2-1/2" pipe for the best flow. Your clutches will run as cool as the factory setup and you will notice a power gain on the engine with an increase of 200 rpm over the stock intake system. This is a complete kit that includes all engine and clutch snorkels, brackets, couplings, and vent extensions needed to make your RZR fully snorkeled and ready for anything. Instructions and pictures will help you with the install that can be performed with common tools, minimal skill and less than 2 hours time.



I am a Master plumber by trade, and have been building custom everything for 20 years. These snorkel kits are built with the best workmanship you will find, all pieces are cut on a chop saw - square, then chamfered and beveled for a perfect fit in each fitting. After each section is assembled, it is pressure tested to insure there are no leaks - could you imagine?!? And that's right I said ASSEMBLED!! Your kit will arrive ready to bolt on - no need to buy glue, and align fittings. All you have to do is drill a few holes, pull the bed off and make 1 cut to an existing duct. You can do this in about 1-2 hours start to finish and your machine will be ready to go as deep as you dare - you may want to keep a life jacket on board!! My kits are priced higher than the rest because you get 3 times the product - literally. They are PRE-ASSEMBLED. They are PRESSURE TESTED for reliability. They are custom built to blend in with the stock roll bars. Simply put, they are THE best!! Oh and free shipping - no hidden cost!!






DISCLAIMER:  Do not operate the machine through water deeper than the manufacture recommends. Any operation beyond the manufactures recommendation is at YOUR OWN RISK. I accept no liability as to the performance of this product, or your safety, it is intended only to convey clean cool air to the machines vitals drawn from the highest possible point of the machine.